Amtrak's Secaucus High Density Cab Signaling in Action

When the Secaucus transfer was being designed and built around the year 2000, Amtrak implemented a new "High Density Cab Signaling" concept with shorter blocks and additional cab signal codes in order to increase the capacity of the approach into Penn Station especially with all the NJT Corridor and Midtown Direct trains stopping at Secaucus. This would replace the PRR era Rule 261 signaling with mile long blocks. Below we see the 2E signal at ERIE interlocking cycle through its indications after an eastbound NJT push-pull takes a Clear signal upon departing the track 2 station platform. 2E was fleeted for a normal route and immediately went to Stop and Proceed, then Slow Approach, Approach, Approach Limited and  finally Cab Speed (which could represent both 60 and 80mph speed codes). The horn at the end was an approaching Amtrak Regional which ultimately took 2E at Clear (not captured on video).

Unfortunately this was just in time for NJT to lean into Push-Pull service which lacked the acceleration to and braking systems to take advantage of the rapidly changing speed codes. On push-pull sets with traditional air brakes, crews would often target one speed below the one being displayed to avoid jerky train handling and the risk of penalty brake applications in the face of frequent cab signal drops.This negated much of the intended speed benefits from the high density cab signals. For whatever reason, similar High Density Cab Signals could be found on the 2005 era western Harrisburg Line re-signaling, however due to the low traffic density, Amtrak has taken to disabling some of these extra code change points.